About Us

 

         COMBINATION SMOKE/HEAT and CARBON MONOXIDE DETECTOR - Wireless

 

The Wireless Combination Smoke/Heat and Carbon Monoxide Detector is a 2xCR123A battery powered wireless detector intended for use with a compatible wireless alarm system. The detector consists of a photoelectric smoke sensor, thermistor heat sensor and electrochemical carbon monoxide sensor coupled to a wireless transmitter, which communicates with the control panel. When fire or carbon monoxide is detected, the detector sounds a loud local alarm and the built-in transmitter sends a signal to the control panel.

 

The Wireless Combination Smoke, Heat and Carbon Monoxide Detector contains an integrated fixed 41°F and 5°C temperature freeze sensor that will send a warning signal based on temperature detected. This detector is designed to provide protection with 70-foot spacing capability. The detector can send alarm, tamper and battery condition messages to the system’s receiver. Refer to the wireless system’s instruction for the maximum number of transmitters that can be supported.

 

The detector has an operational life of 10 years. After 10 years of operation the detector will provide audio visual trouble indication and must be replaced

 

 

 

Features:

- Three technologies, one device:

            Photoelectric smoke detector

            Thermistor heat detector- plus 41° freeze notification

            Electrochemical CO detector

- POWER: Two CR123A Panasonic batteries

- Wireless Signals: Alarm, Tamper, and Low battery

- Detector siren sounds in alarm

            Smoke and heat: Temporal 3

            CO:                       Temporal 4

- Operational life: 10 years

- Push button to Hush feature

- LED indicators

            Red=alarm

            Yellow=trouble/fault

            Green= normal operation

- Detector dirty notification feature

- End of life notification feature

- Low battery notification

 

 

Compatibility and Part Numbers:
RF-APCMB-345-NN:   345 MHz. Honeywell® and 2GIG®